Mount tissue on an AGM VX50 - Stricto Assembly Instructions AGM Scooter

Welcome to Stricto. We will help you to mount a scooter leg cover on the AGM VX50 scooter. The basics are pretty much the same for most scooters. The large strap at the front, the smaller strap at the front and the hooks at the bottom. Because every scooter is slightly different, we walk you through the assembly step by step so that your Stricto scooter leg cover fits perfectly on your AGM VX50.

We explain in 5 steps how you can best install the Stricto leg cover on an AGM VX50 if you DO NOT have crash bars on your scooter.If you have an AGM VX50 with crash bars, click here for the mounting instructions.

Do you have an AGM but no VX50? Then select below which type you have.

> New Flash

> Retro / Grande Retro

> R8 / BRASH50

> Ecoter E1 S

> ECOOTER E2 S30

Instructions AGM VX50 without crash bars

Step 1: remove your scooter leg cover from the packaging and unfold it. Stand at the front of the scooter and put the large Velcro strap under your handlebars and fasten the Velcro strap. Make sure that this strap is already in place, this is more difficult to adjust later.

Step 2: You have two female clips on the left and right of the Stricto scooter leg cover. Attach the strap that comes with it and click it left and right on the lower female clip. Let it hang slightly under the front bonnet. Please note: it should not be tight yet, we will do this later.

Step 3: At the bottom of the AGM VX50 you have a bottom plate. Follow the bottom plate to the rear of the scooter. This is the mounting location for the right hook on the bottom. Make the strap extra long again so that you have enough space.

Step 4: Attach the left hook at the notch, left bottom of the side skirt at the bottom plate next to the side stand.

Step 5: Now carefully tighten the straps 1 by 1. Start with the front strap on the left and right side. Not too hard, otherwise you will pull the scooter leg cover out of shape and over your turn signals. Then tighten the strap of the right hook slightly. Then the strap of the left hook. If the scooter leg cover is already pretty good, but not quite perfect. Repeat these steps. Strap on the front, strap of the hook on the right, strap of the hook on the left. Keep a constant eye on the front so that your Stricto scooter leg cover stays in place.

If you have correctly mounted the Stricto leg cover, it will look like this at the front.