Tissue Vespa Sprint Primavera ELETTRICA assemble - Stricto Assembly instructions Vespa Scooter
Welcome to Stricto. We will help you to mount a scooter leg cover on the Vespa Sprint, Vespa Primavera or Vespa Elettrica. The basics are pretty much the same for most scooters. The large strap at the front, the smaller strap at the front and the hooks at the bottom. Because every scooter is slightly different, we walk through the assembly step by step so that your scooter leg cover fits perfectly on your Vespa.
We explain in 5 steps how you can best mount the Stricto scooter leg cover on a Vespa Sprint / Vespa Primavera / Vespa Elettrica WITHOUT crash bars. Click here if you have crash bars on your vespa. If you have a different Vespa or Piaggio scooter, click underneath on your model.
> Piaggio Zip
> Piaggio One
> Piaggio Medley / Beverly
> Vespa LX / S / LXV
Instructions Vespa Sprint, Vespa Primavera and Vespa Elettrica without the crash bars.
Step 1: Remove your leg cover from the packaging and unfold it. Stand at the front of the scooter and put the large Velcro strap under your handlebars and fasten the Velcro strap. Make sure that this band is already in place, this is more difficult to adjust later
Step 2: You have two female clips on the left and right of the Stricto scooter leg cover. Attach the strap that comes with it and click it left and right on the bottom clip. Let it hang slightly under the front bonnet. Please note: the straps should not be tight yet, we will do this later.
Step 3: At the bottom of the Vespa Sprint, Primavera and the Elettrica you have a bottom plate made of steel. There are several rubber covers here. At the front, there is a rectangular rubber item. This is the mounting location for the right hook on the bottom. Make the strap extra long again so that you have enough slack. If there is a rubber in it, you can pull it out. Click here for the instructions for a Vespa with crash bars.
Step 4: Attach the left hook on the notch of the side stand to the plastic coverp.
Step 5: Now carefully tighten the straps 1 by 1. Start with the front strap on the left and right side. Not too hard, otherwise you will pull the leg cover out of shape and over your turn signals. Then slightly tighten the strap of the right hook. Then the strap of the left hook. If the leg cover is already pretty good, but not quite perfect. Repeat these steps. Strap on the front, strap of the hook on the right, strap of the hook on the left. Keep a constant eye on the front so that your Stricto scooter leg cover stays in place.
If you have correctly mounted the Stricto scooter leg cover, it will look like this at the front.
